Skip to content
Markdown
GuideForOwnerWith Foxden Admin

Choose whether assistants ask before acting ​

This page lets an Owner decide whether AI assistants connected to Foxden stop and ask their person before they delete, send or spend, or go ahead on their own. It is one setting for the whole company, in Foxden Admin.

What the setting does ​

Some tools in the apps change things that are hard to take back: deleting a record, sending a document for signature, placing a call. Before running one, the app asks for a confirmation.

  • On (the default). The setting reads Let assistants run every tool without asking. The gateway confirms for the person, so the assistant uses every tool its person has access to without stopping, including ones that delete, send or cost money. Scheduled tasks run the same way. The gateway also tells assistants that every tool is allowed, so apps such as Claude do not show their own approval prompts.
  • Off. The gateway passes the app's question back to the assistant, with the words Nothing was done. The assistant shows the person what it is about to do and only calls again once they agree. Tools show their real hints (read-only, destructive), so the assistant's own app may also ask before each change. A scheduled task that needs a confirmation is refused instead of run.

The setting never changes what an assistant may reach. An assistant always has exactly the access of its person, or of its agent identity; this setting only decides whether it asks first.

New companies start with the setting on. A company stays on until an Owner turns it off.

Before you start ​

  • You are an Owner in Admin. People with View only access to Admin see the setting but not the checkbox; their page says Only an Owner can change this.

Change the setting ​

  1. In Admin, open Workspace › Assistants.
  2. Under Asking before acting, tick or clear Let assistants run every tool without asking.
  3. Select Save.

The same setting also appears at the top of Assistant rules (Workspace › Assistants › Rules).

The change is recorded in Workspace › Activity.

When the change takes effect ​

  • Whether the gateway confirms for a person is read on every call, so it applies from the next call.
  • What an assistant was told when it connected (its instructions and each tool's hints) was fetched at connection. To see the new behaviour in the assistant's own prompts, reconnect it (in Claude Code, run /mcp and reconnect foxden).

What people see on their connection page ​

When the setting is on, each person's connection page offers Skip the approval prompts: how to choose Always allow in Claude, and the line to add to Claude Code's ~/.claude/settings.json so it stops asking for each tool:

json
{
  "permissions": {
    "allow": ["mcp__foxden__*"]
  }
}

When it is off, the page says Your workspace has assistants check with you before a tool changes anything.

The foxden mcp install command writes that Claude Code line by default; --ask-each-time leaves it out, so Claude Code keeps asking before each tool even when the company setting is on.

Stop one assistant or tool instead ​

If you want most assistants to run freely but need to stop one, use Assistant rules: pause one connection, pause a person's assistant in one app, take a tool offline, or limit a tool's calls per day. See Assistants.

Foxden is open source under Apache-2.0.